Caution: If a window is cracked but still intact, crisscross the window with
masking tape in order to reduce the risk of damage or personal injury.
Important: Before cutting out a stationary window, apply a double layer of masking tape
around the perimeter of the painted surfaces and the interior trim.
- Open the rear compartment lid in order to access the reveal molding.
- Remove the lock pillar garnish moldings. Refer to
Lock Pillar Upper Garnish Molding Replacement
in
Interior Trim.
- Disconnect
the rear window electrical connectors.
Caution: If broken glass falls into the defroster outlets, it can be blown into
the passenger compartment and cause personal injury.
- Cover the seats and carpeting to protect them from broken glass.
Caution: When working with any type of glass or sheet metal with exposed or rough
edges, wear approved safety glasses and gloves in order to reduce
the chance of personal injury.
Important: The rear window reveal molding fills the cavities between the body and window.
- If the reveal molding is stretched or damaged, it cannot be reused. It must
be replaced.
- Remove the rear window reveal molding (1). Refer to
Rear Window Reveal Molding Replacement
.
If the rear window reveal molding will not release, use a utility knife in order
to cut around the window in order to remove the rear window reveal molding.
Important: Keep the cutting edge of the tool against the rear window.
- This will allow the urethane adhesive to be separated from the window.
| • | Leave a base of urethane on the pinchweld flange. |
| • | The only suitable lubrication is clear water. |
- With the aid of an assistant, use the suction
cups in order to lift the rear window from the opening.
