Callout
| Component Name
|
Preliminary Procedures
- Support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Remove the tire and wheel. Refer to
Tire and Wheel Removal and Installation
.
- Remove the front brake rotor. Refer to
Front Brake Rotor Replacement
.
|
1
| Wheel Drive Shaft Retaining Nut
Notice: Refer to Fastener Notice in the Preface section.
Tighten 110 N·m (81 lb ft) |
2
| Wheel Speed Sensor Connector
Tip If equipped, during removal, note the orientation of the wheel speed sensor pigtail. |
3
| Wheel Bearing/Hub Assembly Bolt (Qty: 3)
Notice: This is a self-retaining fastener joint that does not require thread locking
compounds. Do not attempt to clean the threads with a standard tap. If a standard
tap is used, damage to the joint threads will occur.
Tighten 115 N·m (85 lb ft) |
4
| Wheel Bearing/Hub Assembly
Tip In order to disengage the wheel driveshaft from the wheel bearing/hub assembly, use one of the following tools:
J 28733-B
Wheel Hub Remover, 7208A Hub remover - OTC, CJ129
Universal Hub Puller - Snap-On, 7394 Universal Hub Puller - OTC. |
5
| Wheel Bearing/Hub Assembly Spacer
Tip Note the orientation of the bearing/hub spacer during removal to aid in installation. |