Rear Door Wind Noise (Apply Sealer)

Some customers may comment on wind noise coming from the rear door stationary glass.

This condition may be caused by the rubber seal surrounding the stationary glass not making contact to the door frame.

1. Remove the rear door stationary door glass following SI Document ID 1549117.
2. Apply a 5 mm (1/4 in) bead of 3M® Bedding & Glazing Compound around the center of the stationary door glass frame.



3. When reinstalling the stationary glass, there is a metal tang at the top of the division post. Pull the vent glass down and rearward until you hear this metal tang seat into the square hole in the door frame. Refer to the arrow in the illustration above.
4. Reinstall the door trim following SI Document ID 1549117.

For vehicles repaired under warranty, use: