Scan Tool Data List. Chevrolet Cobalt 2007

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2007 🢒 Cobalt 🢒 Transmission/Transaxle 🢒 Manual Transmission - Getrag 5 Speed 🢒 Scan Tool Data List

Table 1:	2.2L (L61)
Table 2:	2.4L (LE5)

Use the scan tool data values under the following conditions:

•	The Diagnostic System Check - Vehicle is complete.

•	The On-Board Diagnostics are functioning properly.

•	There are no diagnostic trouble codes (DTCs) present.

The values below represent a typical display recorded from a properly functioning system.

Important: Do not use a scan tool that displays faulty data. Report the condition to the scan tool manufacturer. The use of a faulty scan tool can result in misdiagnosis and the unnecessary replacement of parts.

Only the parameters listed below are used in this manual for diagnosing. If a scan tool displays other parameters, the values are not recommended by General Motors for use in diagnosis.

Scan tool values below were recorded under the following conditions:

•	Engine at idle

•	Upper radiator hose hot

•	Closed throttle

•	Transmission in Neutral

•	Closed Loop operation

•	Accessories OFF

•	Brake pedal not applied

2.2L (L61)

Scan Tool Parameter

*Data List

Units Displayed

Typical Data Value

CPP Switch (If Equipped)

1, 9, 11, 15

Applied/ Released

Released

Vehicle Speed Sensor

ALL

km/h (mph)

*Data List Legend

•	Engine Data (1)

•	Air Data (2)

•	EVAP Data (3)

•	Fuel Trim Data (4)

•	H02S Data (5)

•	Ignition Data (6)

•	Induction Data (7)

•	Misfire Data (8)

•	TAC Data (9)

•	Cooling/HVAC Data (10)

•	Cruise/Traction Data (11)

•	Electrical/Theft Data (12)

•	IPC Data (13)

•	Auto. Transmission Data (14)

•	Manual Transmission Data (15)

•	I/M Data (16)

2.4L (LE5)