Removal Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Clean any debris away that may be present around the evaporative emission
(EVAP) canister vent filter cover.
- Disconnect the fuel fill vent pipe quick connect fitting (2) from the
EVAP canister. Refer to
Plastic Collar Quick Connect Fitting Service
.
- Using a flat-bladed screwdriver, carefully
release the retaining tabs (1) on the EVAP canister filter cover.
- Remove the EVAP canister filter cover.
- Remove and discard the EVAP canister filter.
- Remove and discard the EVAP canister filter cover seal from the cover.
- Clean the inside of the EVAP canister filter housing with a clean shop
towel.
Installation Procedure
- Install a NEW seal to the EVAP canister filter cover. Ensure that the seal is
properly seated to the cover.
- Install a NEW filter to the EVAP canister filter housing.
- Install the canister filter cover.
- Ensure that the filter cover retaining tabs (1) are secured to the canister.
- Connect the fuel fill vent pipe quick connect
fitting (2) to the EVAP canister. Refer to
Plastic Collar Quick Connect Fitting Service
.
- Lower the vehicle.