GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 43650 Balance Shaft Bushing Remover/Installer


    Object Number: 598032  Size: SH

    Important: Service the balance shafts as an assembly. Do not disassemble or assemble the balance shafts.

  1. Install the balance shaft bushing using the J 43650 .

  2. Object Number: 598033  Size: SH
  3. Seat the balance shaft bushing into the bore using the J 43650 and a wrench.
  4. When the J 43650 is fully seated in the engine block, remove it with a wrench.

  5. Object Number: 412419  Size: SH

    Important: 

       • If the balance shafts are not properly timed to the engine, the engine may vibrate or make noise.
       • Install the balance shaft assemblies to the engine using the following steps:

  6. Place the number 1 piston at top dead center (TDC).
  7. Lubricate the balance shaft lobes with engine oil.
  8. Install the balance shafts into their bores.
  9. Notice: Refer to Fastener Notice in the Preface section.

  10. Install the balance shaft retaining bolts.
  11. Tighten
    Tighten the balance shaft retaining bolts to 10 N·m (89 lb in).