Tools Required

J 44887 Oil Filter Wrench

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Place a drain pan under the oil drain plug.



3. Remove the oil pan drain plug.

Important: DO NOT use an open end wrench on the hex on top of the oil filter cap.

4. Use J 44887 to remove the oil filter cap.



5. Remove the oil filter cap with filter.
6. Remove the filter from the cap.

1. Install the filter to the cap.
2. Install the oil filter cap with filter.

Notice: Over torquing the oil filter cap may cause damage to the oil filter cap resulting in an oil leak.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Important: DO NOT use an open end wrench on the hex on top of the oil filter cap.

3. Use J 44887 on the oil filter cap .

Tighten
Tighten the oil filter cap until fully seated, DO NOT exceed 25 N·m (18 lb ft).




4. Install the oil pan drain plug.

Tighten
Tighten the oil pan drain plug to 25 N·m (18 lb ft).

5. Lower the vehicle.
6. Fill the engine with oil. Refer to Fluid and Lubricant Recommendations .