GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Cobalt 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Clutch Pedal Replacement

Removal Procedure

    Object Number: 2006277 Size: SH
  1. Remove the clutch pedal pivot nut (1).

    2. Object Number: 1992138 Size: SH
  2. Disconnect the electrical connector (1) from the clutch position sensor (2)

    3. Object Number: 1553006 Size: SH
  3. Depress the tabs of the clutch master cylinder pushrod retainer and release the clutch pedal from the pushrod.

    4. Object Number: 2006278 Size: SH
  4. Remove the clutch pedal bracket to front of dash nuts (2).
  5. Remove the steering column mounting bolts. Move the steering column enough to have clearance to remove the clutch pedal and pedal bracket assembly. Refer to Steering Column Replacement .
  6. Remove the clutch pedal assembly (1).

Installation Procedure

    Object Number: 2006278 Size: SH
  1. Install the clutch pedal assembly (1).

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the clutch pedal bracket to front of dash nuts (2).

    3. Tighten
    Tighten the nuts to 10 N·m (89 lb in).

  3. Move the steering column to the original position and install the mounting bolts. Refer to Steering Column Replacement .

    4. Object Number: 1553006 Size: SH
  4. Install the clutch master cylinder pushrod to the clutch pedal, ensure that the pushrod retainer is fully seated to the pedal.

    5. Object Number: 2006277 Size: SH
  5. Install the clutch pedal pivot nut (1).

    6. Tighten
    Tighten the nut to 10 N·m (89 lb in).


    Object Number: 1992138 Size: SH
  6. Connect the electrical connector (1) to the clutch position sensor (2)

    7. Warning: Replacement or reprogramming of the ECM, or replacement of the clutch pedal position sensor (CPPS) or clutch pedal requires that a CPPS learn procedure be performed. Failure to perform the CPPS learn procedure may result in personal injury or damage to the vehicle or its components if the vehicle is in gear and the starter motor is accidentally engaged.

  7. Perform the clutch pedal position sensor learn procedure. Refer to Clutch Pedal Position Sensor Learn for Getrag 5 speed transmission or Clutch Pedal Position Sensor Learn for MU3 transmission.