Removal Procedure
- Disconnect the connector position assurance (CPA) from the accelerator pedal position (APP) sensor connector.
- Disconnect the APP sensor harness connector.
- Remove the APP assembly attachment bolts from the brake pedal assembly.
- Remove the APP assembly from the vehicle.
Installation Procedure
- Install the upper attachment bolt into the APP assembly.
- Install the APP assembly into the vehicle.
Notice: Refer to Fastener Notice in the Preface section.
- Install the attachment bolts into the APP assembly.
Tighten
Tighten the accelerator pedal position assembly-to-brake bracket bolt to 9 N·m (80 lb in).
- Connect the APP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.
- Install the APP sensor connect CPA.