Ignition and Start Switch Replacement. Chevrolet Cobalt 2008

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2008 🢒 Cobalt 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 Ignition and Start Switch Replacement

Callout	Component Name
Preliminary Procedures Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement.
1	Ignition and Start Switch Bolt (Qty: 2) Notice: Refer to Fastener Notice in the Preface section. Procedure Turn the ignition lock cylinder to the run position before removing the ignition and start switch bolts. Tighten 2 N·m (18 lb in)
2	Ignition and Start Switch Procedure Disconnect any electrical connectors as needed.

Callout

Component Name

Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.
Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement.

Ignition and Start Switch Bolt (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Turn the ignition lock cylinder to the run position before removing the ignition and start switch bolts.

Tighten
2 N·m (18 lb in)

Ignition and Start Switch

Disconnect any electrical connectors as needed.