DTC P2544. Chevrolet Cobalt 2008

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2008 🢒 Cobalt 🢒 Safety and Security 🢒 Supplemental Inflatable Restraints 🢒 DTC P2544

Diagnostic Instructions

•	Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

•	Review Strategy Based Diagnosis for an overview of the diagnostic approach.

•	Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P2544: Transmission Torque Request Circuit

To improve shift feel, the transmission control module (TCM) may request that the engine control module (ECM) reduce engine torque during shift events. When such a request is received, the ECM responds by retarding the base ignition timing and notifying the TCM that the request has succeeded. If the ECM is unable to comply with the request, the ECM sends the TCM a message that the request has failed.

The torque reduction request is sent to the ECM through a communication network called the controller area network (CAN). Two circuits are used to communicate CAN data between the ECM and TCM. A fault in the CAN will not cause DTC P2544 to set by itself. If a CAN fault occurs, other DTCs will set before DTC P2544.

When the TCM receives a torque reduction failure message from the ECM, then DTC P2544 will set.

Conditions for Running the DTC

•	The engine run time is greater than 5 seconds.

•	No other CAN errors are present.

Conditions for Setting the DTC

The ECM notifies the TCM that a torque reduction request has failed for 2 seconds.

Action Taken When the DTC Sets

•	DTC P2544 is a Type B DTC.

•	The TCM commands maximum line pressure.

•	The TCM freezes transmission adaptive functions.

•	At the time of the first failure, the TCM records the operating conditions when the Conditions for Setting the DTC are met. The TCM stores this information as a Failure Record.

•	At the time of the second failure, the ECM records the operating conditions when the Conditions for Setting the DTC are met. The ECM stores this information as a Freeze Frame.

•	The TCM stores DTC P2544 in TCM history.

Conditions for Clearing the DTC

•	DTC P2544 is a Type B DTC.

•	The ECM turns OFF the malfunction indicator lamp (MIL) after the sixth consecutive drive trip in which the TCM does not send a MIL illumination request.

•	A scan tool can clear the DTC.

•	The TCM clears the DTC from TCM history if the vehicle completes 40 warm-up cycles without a non emission related diagnostic fault occurring.

•	The TCM cancels the DTC default actions when the ignition is OFF long enough in order to power down the TCM.

Diagnostic Aids

This diagnostic trouble code may set due to low system voltage. Ensure that the vehicle battery has passed a load test and is completely charged. Refer to Battery Inspection/Test. Verify charging system is operating correctly. Refer to Charging System Test. Verify there is no parasitic drain on the battery. Refer to Battery Electrical Drain/Parasitic Load Test.