GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Cobalt 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Hood Primary and Secondary Latch Replacement

Removal Procedure
  1. Raise the hood.
  2. Mark the hood latch location to the support bracket with a grease pencil.

    3. Object Number: 863868 Size: SH
  3. Remove the hood latch bolts.

    4. Object Number: 863872 Size: SH
  4. Disconnect the release cable from the hood latch by squeezing the cable retainer.
  5. Remove the hood latch from the vehicle.

Installation Procedure

    Object Number: 863872 Size: SH
  1. Install the hood latch release cable to the hood latch.
  2. Position the hood latch to the alignment marks on the support bracket.

    3. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the hood latch bolts.
  4. Tighten the latch bolts with the latch in the full up position.
  5. Slowly close the hood and press down until the hood is flush with the fenders.
  6. Raise the hood.

    7. Tighten
    Tighten the bolts to 10 N·m (89 lb in).

  7. Adjust the hood, if required. Refer to Hood Adjustment.
  8. Close the hood.