Special Tools

J-21177-A Drum to Brake Shoe Clearance Gage

Warning: Refer to Brake Dust Warning in the Preface section.

Note: The park brake cable nut is a nylon lock type. Use ONLY HAND TOOLS when loosening or tightening the adjusting nut.

1. Ensure the park brake lever is in the fully released position.
2. Release the park brake lever boot from the floor console by applying light pressure inward on the sides of the boot retainer.
3. Pull the boot away from the console to expose the front park brake cable adjusting nut (1).
4. Release the tension from the park brake cable system at the front cable adjusting nut.

Using ONLY HAND TOOLS, loosen the adjusting nut completely to the end of the front cable threaded rod.




5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
6. Remove the rear tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation.
7. Remove the brake drums. Refer to Brake Drum Replacement.
8. Position the J-21177-A Drum to Brake Shoe Clearance Gage to widest point of the brake drum inside diameter.
9. Firmly hand tighten the set screw on the J-21177-A Drum to Brake Shoe Clearance Gage .



10. Remove the J-21177-A Drum to Brake Shoe Clearance Gage from the brake drum and position it over the corresponding brake shoe assembly at its widest point.
11. While holding the J-21177-A Drum to Brake Shoe Clearance Gage in position, insert a 0.375 mm (0.015 in) feeler gage between one side of the J-21177-A Drum to Brake Shoe Clearance Gage , and the corresponding brake shoe lining.
12. Rotate the brake shoe adjuster screw until the brake shoe linings contact the J-21177-A Drum to Brake Shoe Clearance Gage , and the feeler gage.

Specification
Brake shoe lining-to-drum clearance: 0.375 mm (0.015 in).

13. Repeat the above steps for the opposite brake drum and brake shoe assembly.
14. Install the brake drums. Refer to Brake Drum Replacement.
15. Adjust the park brake. Refer to Parking Brake Adjustment.
16. Install the rear tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation.
17. Lower the vehicle.
18. Position the park brake lever boot to the floor console and press the boot retainer into place to secure.