Removal Procedure
- Remove the instrument panel (I/P) center trim panel. Refer to
Instrument Panel Center Trim Panel Replacement.
- Remove the HVAC control module assembly screws.
- Remove the HVAC control module assembly.
Note: The HVAC control connector-1 and the radio connector-2 can be interchanged. Mark or place tape on the connector to avoid accidental interchange.
- Disconnect the HVAC control module assembly electrical connectors.
Installation Procedure
- Connect the HVAC control module assembly electrical connectors.
- Install the HVAC control module assembly.
Caution: Refer to Fastener Caution in the Preface section.
- Install the HVAC control module screws.
Tighten
Tighten the screws to 2.2 N·m (19 lb in).
- Install the I/P center trim panel. Refer to
Instrument Panel Center Trim Panel Replacement.