GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Colorado Pickup - 2WD 🢒 Bulletins 🢒 SMU - Revised Ignition Switch Replacement

SMU - Revised Ignition Switch Replacement

Subject:Revised Ignition Switch Replacement

Models:2004-2006 Chevrolet Colorado
2004-2006 GMC Canyon
2006 HUMMER H3


This bulletin is being issued to revise the Ignition Switch Replacement procedure in the Steering Wheel and Column sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.

The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin on the affected page.

Ignition Switch Replacement
Object Number: 1749570 Size: MF

Callout

Component Name

Notice: Refer to Fastener Notice in Cautions and Notices.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.

Preliminary Procedures

  1. Disable the SIR system. Refer to SIR Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable.
  3. Remove the lower steering column trim cover. Refer to Steering Column Trim Covers Replacement.

1

Ignition Switch Electrical Connector

2

Ignition Switch Screw (Qty: 2)

Torque
0.74 N·m (7 lb in)

3

Ignition Switch

Tip

  1. The ignition lock cylinder must be in the run position prior to removal of the ignition switch or damage to the components can occur.
  2. Reprogram the theft deterrent system. Refer to Programming Theft Deterrent System Components.