For 1990-2009 cars only
Removal Procedure
- Install a 3/8 inch breaker bar into the drive belt tensioner (7) and rotate the tensioner (7) clockwise, enough to relieve the tension on the drive belt (1).
- Slide the drive belt (1) from the water pump pulley (2).
- Allow the drive belt tensioner (7) to return to the relaxed position.
- Remove the drive belt (1) from the remaining pulleys.
Installation Procedure
- Route the drive belt (1) over all the pulleys, excluding the water pump pulley (2).
- Install the 3/8 inch breaker bar on the drive belt tensioner (7) and rotate the tensioner (7) clockwise.
- Route the drive belt (1) over the top of the water pump pulley (2).
- Slowly release the tension to the drive belt tensioner (7).
- Inspect for proper installation of the drive belt (1) on the pulleys.
Important: Ensure the drive belt is properly aligned and seated into the grooves of the drive pulleys.
