GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Colorado Pickup - 2WD 🢒 Body Systems 🢒 Lighting 🢒 Parking Brake Indicator Switch Replacement

Removal Procedure

    Object Number: 303362 Size: SH
  1. Remove the knee bolster trim panel. Refer to Knee Bolster Replacement .

    2. Object Number: 792097 Size: SH
  2. Remove the electrical connector.

    3. Object Number: 792100 Size: SH
  3. Remove the park brake warning lamp switch mounting bolt.

    4. Object Number: 792101 Size: SH
  4. Remove the park brake warning lamp switch from the vehicle.

Installation Procedure

    Object Number: 792101 Size: SH
  1. Install the park brake warning lamp switch.

    2. Object Number: 792100 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the park brake warning lamp switch mounting bolt.

    3. Tighten
    Tighten the park brake warning lamp switch mounting bolt to 4 N·m (35 lb in).


    Object Number: 792097 Size: SH
  3. Install the electrical connector.

    4. Object Number: 303362 Size: SH
  4. Install the knee bolster trim panel. Refer to Knee Bolster Replacement .