GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Colorado Pickup - 2WD 🢒 Safety and Security 🢒 Seat Belts 🢒 Rear Seat Belt Replacement

Removal Procedure

    Object Number: 1276833 Size: SH
  1. Open the rear seat belt upper guide shoulder bolt trim cover.
  2. Remove the rear seat belt upper guide shoulder bolt.
  3. Remove the body rear corner trim panel. Refer to Body Side Rear Lower Trim Panel Replacement .

    4. Object Number: 1276834 Size: SH
  4. Remove the rear seat belt anchor bolt.
  5. Remove the bolt that retains the seat belt retractor assembly to the body.
  6. Remove the rear seat belt assembly from the vehicle.

Installation Procedure
  1. Position the rear seat belt retractor assembly to the vehicle.

    2. Object Number: 1276833 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the bolt which retains the seat belt retractor assembly to the body.

    3. Tighten
    Tighten the rear seat belt retractor bolt to 52.5 N·m (39 lb ft).

  3. Install the rear seat belt upper guide with the bolt. Ensure that the seat belt webbing is not twisted.

    4. Tighten
    Tighten the rear seat belt upper guide bolt to 52.5 N·m (39 lb ft).

  4. Install the rear seat belt upper guide shoulder bolt trim cover.
  5. Install the body rear corner trim panel. Refer to Body Side Rear Lower Trim Panel Replacement .

    6. Object Number: 1276834 Size: SH
  6. Install the rear seat belt anchor bolt. Ensure that the seat belt webbing is not twisted.

    7. Tighten
    Tighten the rear seat belt anchor bolt to 52.5 N·m (39 lb ft).