GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Chevrolet
🢒
2009
🢒
Colorado Pickup - 2WD
🢒
Engine
🢒
Engine Mechanical - 3.7L
🢒 Engine Mount Replacement - Left Side
Removal Procedure
Remove the left wheel and tire assembly. Refer to
Tire and Wheel Removal and Installation
.
Remove the engine shield, if equipped. Refer to
Engine Protection Shield Replacement
.
Remove the lower intermediate steering shaft. Refer to
Lower Intermediate Steering Shaft Replacement
.
Support the engine using a jack stand and a block of wood.
Remove the engine mount-to-frame bracket through bolt for the mount being replaced.
Loosen the right side through bolt.
Remove the heater pipe bracket bolt from the engine mount. Refer to
Heater Outlet Hose Replacement
.
Raise the engine using the jack stand; the engine will tilt to one side.
Remove the engine mount bolts.
Remove the engine mount. You will need to articulate the mount in order to remove the mount.
Installation Procedure
Install the engine mount. You will need to articulate the mount in order to install the mount.
Install the engine mount bolts.
Caution:
Refer to
Fastener Caution
in the Preface section.
To aid in the installation of the bolts, start a bolt in position (1) first and tighten to
50 N·m (37 lb ft)
.
Lower the engine.
Install the engine mount-to-frame bracket through bolt and tighten to
85 N·m (63 lb ft)
.
Install the engine coolant pipe bracket bolt from the engine mount. Refer to
Heater Outlet Hose Replacement
.
Remove the jack stand.
Install the lower intermediate steering shaft. Refer to
Lower Intermediate Steering Shaft Replacement
.
Install the engine shield, if equipped. Refer to
Engine Protection Shield Replacement
.
Install the left wheel and tire assembly. Refer to
Tire and Wheel Removal and Installation
.
Lower the vehicle.