Special Tools

J 44221 Camshaft Holding Tool

For equivalent regional tools, refer to Special Tools.

1. Coat the camshaft journals, camshaft journal thrust face, and camshaft lobes with clean engine oil.
2. Install the exhaust camshaft.
3. Install the intake camshaft.



4. Install J 44221 holding tool with the camshaft flats up and the number 1 cylinder at top dead center.




Note: Install the same camshaft cap onto the same camshaft journal from which it was removed. The camshaft caps are pin stamped for direction and numerical order.

5. Install the exhaust camshaft caps.
6. Install the intake camshaft caps.

Caution: Refer to Fastener Caution in the Preface section.

7. Install the camshaft cap bolts. Tighten the bolts evenly in order to compress the valve springs before final torque. Tighten the camshaft cap bolts to 12 N·m (106 lb in).
8. Remove J 44221 holding tool .