For 1990-2009 cars only
Removal Procedure
- Disconnect the electrical connectors (2, 4) from the following components:
- Complete the following in order to disengage the retainer (3) from the clutch pedal pin.
- Remove the 4 nuts securing the clutch pedal assembly to the cowl.
- Remove the clutch pedal assembly from the vehicle.
| • | The clutch pedal position switch (1) |
| • | The cruise control release switch (3) |
Note: A new retainer (3) is required after removal.
| 2.1. | Insert a flat-bladed tool (4) between the clutch master cylinder push rod (1) and the clutch pedal (2). |
| 2.2. | Pry the clutch master cylinder push rod (1) away from the clutch pedal assembly (2). |
Discard the retainer (3).
Installation Procedure
- Position the clutch pedal assembly over the studs.
- Install the clutch pedal assembly nuts and tighten to 20 N·m (15 lb ft).
- Insert a new retainer (3) into the clutch master cylinder push rod (1).
- Push the clutch master cylinder push rod (1) onto the clutch pedal pin to secure.
- Connect the electrical connectors (2, 4) to the following components:
- Adjust the clutch release switch. Refer to Clutch Pedal Cruise Control Release Switch Adjustment.
- Adjust the clutch pedal position switch. Refer to Clutch Pedal Position Switch Replacement.
- Check for proper clutch pedal movement and operation.
Caution: Refer to Fastener Caution in the Preface section.
| • | The clutch pedal position switch (1) |
| • | The cruise control release switch (3) |
