For 1990-2009 cars only
Removal Procedure
- Open the sunshade to the full open position.
- Remove the sunroof module upper frame. Refer to Sunroof Frame Replacement - Upper .
- Remove the guides (1) from the sliders (2).
- Remove the drive cables and sliders (1) from the guides.
- Remove the lever (1) by rotating it forward and slide it together with the locker slider forward.
- Remove the lever carefully by using a flat-bladed tool between the track and the levers.
- Remove the front end of the locker slider to the outside and slide it forward.
- Apply a light coat of lubricant (1) to the following parts:
The track is not serviceable. If damaged replace the sunroof window.
| • | The guides |
| • | The curve of the driving slider |
| • | The lever |
| • | The locker sliders |
| • | The track is not serviceable. If damaged replace the sunroof window. |
| • | It bonded to the sunroof window panel. |
Installation Procedure
- Place the locker slide, with the front to the outside, and slide it rearward.
- Slide the locker slider forward.
- Push the pin (1) of the lever (2) carefully through the track (3) in the locker slide.
- Slide the lever together with the locker slide rearward, and rotate the lever rearward.
- Mount the driving slide (1) to the lever and the front tumbler.
- Position the front tumbler and the driving slide in-line with each other.
- Slide the guide carefully over the front tumbler and driving slider extends 4.5 cm (2 in) out of the guide.
- Mount the drive cable on the driving slide.
- Rotate the drive cable, so that the points of the oval cable end fit into the guides.
- Slide the guides rearwards until the end of the driving slide is 1 cm (3/8 in) within the guide.
- Install the sunroof module upper frame. Refer to Sunroof Frame Replacement - Upper .
- Verify the operation of the sunroof.
- Close the sunshade.
Important: Do Not force the guides to the sliders. Use care.
