• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
The BCM calculates the mileage based on the vehicle speed signal from the engine control module (ECM). The BCM then sends a serial data message to the IPC indicating the value of the odometer. The odometer will display 'error' if an internal BCM memory failure is detected or there is a serial data communication fault. The odometer displays either miles or kilometers and the desired units can be accessed by pressing the trip/reset switch.
Instrument Cluster Description and Operation
• | Circuit Testing |
• | Wiring Repairs |
Control Module References for scan tool information
Ignition ON, press the trip reset button and verify the odometer display toggles between season odometer and trip odometer.
⇒ | If the odometer display does not toggle between season odometer and trip odometer, replace the IPC. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for the IPC replacement, setup, and programming