GM Service Manual Online
For 1990-2009 cars only

Special Tools

J 9886-01 Door Handle Clip Remover

Removal Procedure

  1. Remove the window regulator handle from the door by inserting tool J 9886-01 between the handle and the white plastic washer to remove the retaining clip, if the vehicle is equipped with manual windows.

  2. Object Number: 1276820  Size: SH
  3. Remove the retaining screw from the door handle bezel.

  4. Object Number: 1276818  Size: SH
  5. Remove the 2 retaining screws from the armrest and lift the front of the switch plate to disengage the clip.

  6. Object Number: 1276817  Size: SH
  7. Disconnect the electrical harness (3-4) from the power window switch (2, 5), if equipped.
  8. Remove the upper trim cover from the door.

  9. Object Number: 1276819  Size: SH
  10. Gently pull the door panel away from the door.
  11. Remove any fasteners from the door and reinsert them in the door panel before installing the panel on the door.

Installation Procedure


    Object Number: 1276819  Size: SH
  1. Install the trim panel to the door, ensuring that all the retaining tabs are fully seated.

  2. Object Number: 1276817  Size: SH
  3. Connect the electrical harness (3-4) to the power window switch (2, 5), if equipped.
  4. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1276818  Size: SH
  5. Install the 2 retaining screws in the switch plate. Tighten the front door switch plate screws to 2 N·m (18 lb in).

  6. Object Number: 1276820  Size: SH
  7. Install the retaining screw in the door handle bezel. Tighten the front door handle bezel screws to 2 N·m (18 lb in).
  8. Install the window regulator handle from the door and insert the clip between the handle and the white plastic washer, if the vehicle is equipped with manual windows.
  9. Install the upper trim cover to the door.