GM Service Manual Online
For 1990-2009 cars only

DOOR TRIM MAP POCKET RETENTION (SERVICE PROCEDURE)

VEHICLES AFFECTED: 1988-89 CHEVROLET BERETTA

THIS BULLETIN CANCELS AND REPLACES BULLETIN # 831090.

Some owners of 1988 (with passive restraints) and 1989 Berettas with map pockets on the drivers door trim panel may comment, on the map pocket breaking loose at the lower forward hidden screw attaching location. This screw located under the forward edge of the map pocket is covered by carpeting, and MUST BE REMOVED PRIOR TO DOOR TRIM PAD REMOVAL.

Service Procedure:

To reinstall a loose or broken map pocket:

1. Remove door trim panel as outlined in the 1988-89 Service Manual, Body Section Page 10-5-4 and 5, and place on a clean flat surface.

2. Install two number 8 x 1/2 inch trim screws with 1/2 inch O.D. flat washers through the back side of the trim panel into the heat stakes. (See Illustration)

3. Drill a (1/8") hole, approximately 1/2 inch below area to where original retaining screw was located. (See Illustration)

IMPORTANT: A small amount of carpet will have to be removed to prevent the drill from becoming entangled in the carpet.

4. Install trim panel to door and raise glass to full up position, drill a 1/16" pilot hole into door inner panel through the hole drilled in map pocket in Step 3.

5. Drive aflat headed-self tapping 5/32 X 1 inch long screw through map pocket into door inner panel.

Use most applicable Labour Operation and time from the Canadian Labour Time Guide.


Object Number: 76474  Size: FS

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.