FRT. STRUT BEARINGS MAY CAUSE MEMORY STEER (REPLACE BEARING)

Subject: FRONT STRUT BEARINGS MAY CAUSE MEMORY STEER

Model and Year: 1992-93 CORSICA AND BERETTA

THIS BULLETIN CANCELS AND SUPERSEDES DEALER SERVICE BULLETIN NO. 92-209-3B, DATED JUNE 1992. THE 1993 MODEL YEAR HAS BEEN ADDED AND PART NUMBERS REVISED. ALL COPIES OF 92-2O9-3B SHOULD BE DISCARDED.

CONDITION:

On a smooth, flat road, the vehicle may exhibit a type of lead or pull condition. This would be directly following the completion of a turning maneuver. When the steering wheel is returned to a straight ahead position, the vehicle may tend to lead or pull in the last direction turned. This is known as "Memory Steer'. This condition is always noted as being in the same direction as the last turning maneuver.

CAUSE:

The upper strut mounting bearing may be sticking or binding which may cause a preload on the strut. This preload may cause the vehicle to move in the last direction turned, thus causing "Memory Steer".

CORRECTION:

Replace both the upper strut mount assemblies with the following, (2 per vehicle, right and left):

Service Part Number Application

22145610 (Green) FE1 & FE2 Susp., LHO Engine 22145615 (Pink) FE1 & FE2 Susp., LN2 Engine 22145615 (Pink) FE7 Suspension

1. Refer to Dealer Service Bulletin 92-5O-3B for proper diagnosis. If memory steer is found, proceed to next step.

2. Remove both strut assemblies from car, refer to Section 3C in service manual.

3. Disassemble strut, refer to SECTION 3C in the service manual.

4. Install new strut mount assembly.

5. Reassemble strut.

6. Install strut on car, DO NOT INTERCHANGE TOP STRUT BOLT AND BRAKE HOSE BRACKET BOLT! SHORT BOLT MUST GO IN TOP OF STRUT MOUNT.

7. Check front wheel alignment, adjust if necessary.

Parts are currently available from GMSPO.

Labor Operation Number: E-3927

Use applicable labor time guide for labor hours.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.