For 1990-2009 cars only
Removal Procedure
- Grasp both sides of the quick-connect fitting. Twist the female connector 1/4 turn in each direction in order to loosen any dirt within the quick-connect fitting.
- Using compressed air, blow any dirt out of the quick-connect fitting.
- Squeeze the plastic retainer release tabs.
- Pull the connection apart.
Caution: Wear safety glasses when using compressed air in order to prevent eye injury.
Installation Procedure
- Apply a few drops of clean engine oil to the male fuel pipe end.
- Push both sides of the quick-connect fitting together in order to cause the retaining tabs/fingers to snap into place.
- Once installed, pull on both sides of the quick-connect fitting in order to make sure the connection is secure.
Caution: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.