UNIFRAME ALIGNMENT REVISED DIMENSIONS

VEHICLES AFFECTED: 1984 Chevrolet Corvette

The location of Point "F" is incorrectly shown in Figure 2D-2, Section 2D of the 1984 Corvette Shop Manual (ST-364-84). Point "F" has been moved to a drain hole located at the bottom of the outboard rail. This change will affect some of the dimensions called out on Figure 2D-2.

Refer to Figure A for the new Point 'F' location and revised dimensions.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.