REVISED DIFFERENTIAL CASE CROSS PIN INSTALLATION

VEHICLES AFFECTED: 1985 Corvette -------------

Figure 4B-39 shown on Page 4B-16 and step 10 shown on Page 4B17 of the 1985 Corvette Shop Manual (ST-364-85) have been revised as indicated below. Fig. replaces Figure 4B-39 presently shown in the Shop Manual.

10. Position the cross pin shaft in the case and drivit in with a hammer. Be sure the retaining pin hole of the cross pin shaft is properly aligned to allow installation of the retaining pin. Install the retaining pin to the proper depth using a punch and stake in place at both ends of the case.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.