This bulletin revises the Tools Required portion of the SERVICE PROCEDURE section for Chevrolet Product Campaign Bulletin 89C17, dated MARCH, 1990. Specifically, two (2) additional essential tool combinations have been created which may be used in place of the A/C compressor tool kit if necessary. Also, a revised Figure 1 has been included to show the proper combination of these new weight assemblies.
SERVICE PROCEDURE
Tools Required: J-24319-01 - Universal Steering Linkage Puller J-29892-A - (R-4) Compressor Tool Kit (Option 1)
If J-29892-A is not available, one of the following option essential tool combinations may be used:
Option 2 - Geo Essential Tools
J-37758 - Tracker - Transmission Tool J-38412 - Storm - Transaxle Tool J-38462 - Storm - Valve Guide Installer Tool
Option 3 - Corvette Essential Tools
J-35501 - Dana Model 44 Rear Axle Tool J-35505 - Dana Model 44 Rear Axle Tool J-35509 - Dana Model 44 Rear Axle Tool J-35510 - Dana Model 44 Rear Axle Tool
THE PROPER ARRANGEMENT FOR EACH OF THESE COMBINATIONS IS SHOWN IN THE REVISED FIGURE 1 ON PAGE TWO (2) OF THIS SUPPLEMENT.
If none of the tool combinations mentioned in this supplement are available, tool J-29892-A should be ordered to complete this campaign.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.