Tools Required

J 29714-A Servo Cover Depressor

1. Disconnect the negative battery cable. Refer to

   Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

   in General Information.
2. Raise the vehicle. Refer to Section 0A.
3. Support the vehicle with safety stands.
4. Remove the upper and lower underbody braces, if equipped. Refer to Section 10-3.
5. Remove the complete exhaust system. Refer to General Exhaust System Replacement in Engine Exhaust.



6. Remove the transmission oil pan bolt below the servo cover.



7. Install J 29714-A on the oil pan. Install the bolt included with the tool.
8. Use the J 29714-A in order to depress the servo cover and remove the retaining ring..
9. Remove the J 29714-A from the oil pan.



10. Remove the cover and seal ring. The seal may stick in the case.
11. Remove the servo piston and the bore apply pin assembly.
12. Disassemble the 2-4 servo assembly. Inspect the 2-4 servo assembly. Refer to 2-4 Servo Disassemble .

Tools Required

J 29714-A Servo Cover Depressor

1. Install the servo piston and the bore apply pin assembly.
2. Install the 2-4 servo seal ring and the servo cover.



3. Install the J 29714-A and the bolt to the oil pan.



4. Depress the 2-4 band servo cover and install the retaining ring.
5. Remove J 29714-A and the bolt.



6. Install the oil pan bolt.

Tighten
Tighten the bolts to 11 N·m (97 lb in).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

7. Install the exhaust system. Refer to General Exhaust System Replacement in Engine Exhaust.
8. Install the upper and lower underbody braces, if equipped. Refer to Section 10-3.
9. Lower the vehicle.
10. Connect the negative battery cable.