Removal Procedure
- Disconnect the negative battery. Refer to
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
in General Information. - Raise the vehicle. Refer to Section 0A.
- Support the vehicle with safety stands.
- Remove the starter. Refer to Starter Motor Replacement in Engine Electrical.
- Remove the converter cover bolts and the converter cover.
- Remove the flywheel to converter bolts.
Important: Mark the alignment of the flywheel and the converter to retain a proper balance.
Installation Procedure
- Install the flywheel to converter bolts. Hand start the bolts.
- Install the converter cover and the converter cover bolts.
- Install the starter motor. Refer to Starter Motor Replacement in Engine Electrical.
- Lower the vehicle.
- Connect the negative battery cable.
Tighten
Tighten the bolts to 63 N·m (46 lb ft).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 10 N·m (89 lb in).
