Valve Rocker Arm Cover Installation Right Side

Important: All gasket surfaces should be free of oil or other foreign material during assembly.

1. Lubricate the O-ring seal of the NEW oil fill tube with clean engine oil.
2. Insert the NEW oil fill tube into the rocker arm cover and rotate the tube clockwise until locked in the proper position.
3. Install the oil fill cap into the tube and rotate clockwise until locked in the proper position.
4. Install a NEW gasket into the valve rocker arm cover.
5. Install the cover bolts with grommets.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Install the valve rocker arm cover onto the cylinder head.

Tighten
Tighten the valve rocker arm cover bolts to 12 N·m (106 lb in).




7. Install the ignition coils, studs, and bolts (if applicable).

Tighten
Tighten the ignition coil studs and bolts to 12 N·m (106 lb in).

8. Install the ignition coil wire harness (if applicable).
9. Install the ignition coil wire harness connector bolts (if applicable).

Tighten
Tighten the ignition coil wire harness connector bolts to 12 N·m (106 lb in).

10. Install the crankcase ventilation hoses.

Valve Rocker Arm Cover Installation Left Side

Important: All gasket surfaces should be free of oil or other foreign material during assembly.

1. Lubricate the O-ring seal of the NEW vapor vent gourmet with clean engine oil.
2. Insert the NEW vapor vent grommet into the rocker arm cover and rotate the grommet clockwise until locked in the proper position.
3. Install a NEW cover gasket into the valve rocker arm cover.
4. Install the cover bolts with grommets.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the valve rocker arm cover onto the cylinder head.

Tighten
Tighten the valve rocker arm cover bolts to 12 N·m (106 lb in).




6. Install the ignition coils, studs, and bolts (if applicable).

Tighten
Tighten the ignition coil studs and bolts to 12 N·m (106 lb in).

7. Install the ignition coil wire harness (if applicable).
8. Install the ignition coil wire harness connector bolts (if applicable).

Tighten
Tighten the ignition coil wire harness connector bolts to 12 N·m (106 lb in).

9. Install the crankcase ventilation hose.