Caution: When the transmission is at operating temperatures, take necessary precautions when removing the check/fill plug, to avoid being burned by draining fluid.

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Place a drain pan under the transmission.
3. Clean any dirt from around the transmission check/fill plug.
4. Remove the transmission fluid check/fill plug and allow the fluid to drain.



5. Support the transmission oil pan.
6. Remove the transmission oil pan bolts.
7. Loosely reinstall the fluid check/fill plug.
8. Lightly tap the oil pan with a rubber mallet or pry gently in order to loosen the pan.
9. Remove the transmission oil pan.
10. Drain the remaining fluid from the oil pan.

Important: Remove ALL traces of old gasket material from the transmission case and the oil pan gasket surfaces.

11. Clean the oil pan gasket mating surfaces, on both the transmission case and the transmission oil pan, with solvent and air dry.

1. Inspect the oil pan bolts and washers to determine if the conical washers are reversed.

•	Reuse the oil pan bolts and washers if the conical washers are NOT reversed (1).

•	Replace the oil pan bolts and washers if the conical washers are reversed (2).




2. Install the new oil pan gasket to the oil pan sealing surface.
3. Position the oil pan to the transmission case and support the oil pan.
4. Install the oil pan bolts.

Tighten
Tighten the transmission oil pan bolts alternately and evenly to 11 N·m (97 lb in).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




5. Remove the transmission fluid check/fill plug.
6. Fill the transmission with DEXRON®-III automatic transmission fluid through the check/fill plug hole until fluid begins to pour out, then install the check/fill plug hand-tight.
7. Complete filling the transmission with fluid to the proper level. Refer to Automatic Transmission Fluid Level Check/Fill .
8. Inspect the oil pan gasket for leaks.