1. Disconnect the ambient outside temperature sensor connector.
2. Turn the ignition switch to the RUN position.
3. Press the AUTO mode button on the HVAC programmer module.
4. Use a DMM to measure the voltage between terminal A of the ambient outside temperature sensor connector and ground.

Is the voltage within the specified range?

4.5V to 5.5V

Go to Step 3

Go to Step 2

Locate and repair an open or a high resistance in CKT 735.

Is the repair complete?

--

Go to Step 6

--

Use a DMM to measure the voltage between terminal A and terminal B of the ambient outside temperature sensor connector.

Is the voltage within the specified range?

4.5V to 5.5V

Go to Step 5

Go to Step 4

Locate and repair an open or a high resistance in CKT 1798 between the ambient outside temperature sensor connector and S203.

Is the repair complete?

--

Go to Step 6

--

Replace the ambient outside temperature sensor. Refer to Ambient Outside Temperature Sensor in Automatic Air Conditioning.

Is the replacement complete?

--

Go to Step 6

--

1. Press the A/C mode button on the HVAC programmer module. OR
2. Use a Scan Tool to clear the DTCs from memory.

Are the DTCs cleared from memory?

--

Recheck the System Operation (Information not available at the time of printing)

--