Backup Lamp Replacement Assembly

1. Remove the rear license frame.

Carefully depress the locking tabs with a flat-bladed screwdriver.

2. Remove the rear license plate.
3. Remove the backup lamp assembly (w/ rear license bracket) retaining screws.
4. Partially remove the backup lamp assembly to expose the backup lamp sockets.
5. Remove the backup lamp sockets from the backup lamp assembly.
6. Remove the backup lamp assembly (w/ rear license bracket) from the vehicle.

1. Install the backup lamp sockets to the backup lamp assembly (w/ rear license bracket).
2. Install the backup lamp assembly into position on the vehicle.
3. Install the backup lamp assembly (w/ rear license bracket) retaining screws.

Tighten
Tighten the backup lamp assembly (w/ rear license bracket) retaining screws to 2 N·m (18 lb in).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the rear license plate.
5. Install the rear license frame.

Align the locking tabs, then push to lock.

Backup Lamp Replacement Bulb

1. Remove the nearest inner taillamp. Refer to Tail Lamp Replacement .

Access the backup lamp through the taillamp opening.

2. Remove the backup lamp socket from the backup lamp assembly.
3. Remove the bulb from the socket.

1. Install the bulb to the backup lamp socket.
2. Install the backup lamp socket to the backup lamp assembly.
3. Install the inner taillamp. Refer to Tail Lamp Replacement .