DEFINITION: The wiper/washer system works only in HI mode setting.

1. Turn the ignition switch to the RUN position.
2. Turn the wiper switch to the LO position.
3. Using a DMM set in the voltage scale, measure the voltage between terminal E of connector C 209 and good ground.

Is the voltage within the specified range?

1 volt or more

Go to Step 7

Go to Step 2

Check for a poor connection at connector C 209.

Is the connection good?

--

Go to Step 4

Go to Step 3

Repair the connector/connection at connector C 209.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Check for an open in CKT 143 to the wiper/washer switch.

Is there an open present?

--

Go to Wiper/Washer System Check

Go to Step 6

Repair the open to the wiper/washer switch in CKT 143.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Replace the wiper/washer switch.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

1. Disconnect the wiper motor connector.
2. Using a DMM set to the voltage scale, measure the voltage between terminal D of the wiper motor connector and ground.

Is the voltage within the specified range?

1 volt or more

Go to Step 9

Go to Step 8

Repair the open in CKT 91.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Replace the wiper motor cover.

Is the repair complete?

--

Go to Wiper/Washer System Check

--