Removal Procedure
- Open the instrument panel (I/P) passenger compartment door.
- Disconnect the electrical connector from the I/P compartment lamp switch.
- Remove the trim plugs from the bottom of the compartment door.
- Remove the I/P compartment lower retaining bolts.
- Remove the I/P compartment side and upper retaining screws.
- Remove the I/P compartment from the I/P.
Reach behind the compartment door and push the plugs out; use a suitable flat bladed tool on the front side to remove the plugs, if necessary.
Installation Procedure
- Install the I/P compartment to the I/P.
- Install the I/P compartment lower retaining bolts.
- Install the I/P compartment upper retaining screw.
- Align and hold the I/P compartment to the I/P, then install the I/P compartment side retaining screw.
- Install the trim plugs to the I/P compartment door.
- Connect the electrical connector to the I/P compartment lamp switch.
- Close the I/P passenger compartment door.
Tighten
Tighten the I/P compartment lower retaining bolts to 2.5 N·m
(22 lb in).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the I/P compartment upper retaining screw to 1.9 N·m
(17 lb in).
Tighten
Tighten the I/P compartment side retaining screw to 1.9 N·m
(17 lb in).
