Hood Primary and Secondary Latch Replacement Right Side

1. Remove the latch bolts and latch from latch bracket.



2. Disconnect the cable sheath grommet from the latch.
3. Disconnect the cable end from the latch.

1. Install the cable end into the catch on the latch.
2. Install the cable sheath grommet into the slotted hole in the latch.



3. Install the bolts attaching the latch.

Tighten
Tighten the hood latch bolts to 10 N·m (89 lb in).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Hood Primary and Secondary Latch Replacement Left Side

1. Remove the plenum air inlet screen. Refer to Plenum Panel Screens .



2. Remove the bolts attaching the latch.



3. Disconnect the cable sheath grommet from the latch.
4. Disconnect the cable end from the latch.

1. Install the cable end into the catch on the latch.
2. Install the cable sheath grommet into the slotted hole in the latch.



3. Install the hood latch and attaching bolts.

Tighten
Tighten the hood latch bolts to 10 N·m (89 lb in).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




4. Install the plenum screen. Refer to Plenum Panel Screens .