There are five adjustment procedures for aligning the roof lift off panel. Perform the appropriate adjustment(s) as necessary.

1. To adjust the front striker perform the following steps:

1.1.	Loosen the bolts and reposition the latch striker up or down for major adjustment.

1.2.	Loosen the striker outboard bolt and pivot the striker on a slightly loosened inboard bolt in 2 mm (0.08 in) increments for minor up or down roof adjustment.




2. To adjust the front latch handle perform the following steps:

2.1.	Loosen the latch handle bolts.

2.2.	Reposition the latch handle forward or rearward. Maintain a minimum of 2 mm (0.08 in) clearance between latch handle and the latch striker to avoid squeaks and rattles.

2.3.	Assure the latch handle base is parallel to the striker to provide clearance to the sunshade mirror door.




3. For major rear latch adjustment adjust the rear latch striker performing the following steps:

3.1.	Remove the roof lift off panel. Refer to Roof Lift Off Panel Replacement .

3.2.	Remove the roof bow center interior trim panel. Refer to Rear Roof Bow Trim Panel Replacement .

3.3.	Loosen the rear latch striker attaching bolts.

3.4.	Adjust the position of the latch striker forward or rearward for major adjustment.

3.5.	Tighten the striker attaching bolts

Tighten
Tighten the roof rear striker bolts to 10 N·m (89 lab in).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3.6.	Install the roof lift off panel. Refer to Roof Lift Off Panel Replacement .




4. For minor rear latch adjustment adjust the latch handle hook one turn at a time to achieve moderate pressure to the latch as follows.

4.1.	Remove the roof lift off panel. Refer to Roof Lift Off Panel Replacement .

4.2.	Loosen the set screw locking the latch hook.

4.3.	Turn the hook in to tighten or out to loosen.

4.4.	Tighten the set screw.

4.5.	Install the roof panel. Refer to Roof Lift Off Panel Replacement .




5. To adjust the rear locator perform the following steps:

5.1.	With roof installed on the vehicle loosen the locator mounting bolts.

5.2.	Reposition the locator.

5.3.	Retighten the mounting bolts.

Tighten
Tighten the roof rear locator to locator bracket bolts to 10 N·m (89 lb in).