Removal Procedure
- Heat the molding to between
32-38°C (90-100°F) to aid in removal.
- Pull the molding from the front fender.
| • | Cut the adhesive as the molding is pulled loose. |
- Clean any remaining adhesive from the fender using an adhesive
and stripe removal disc or a suitable cleaner:
| • | 3M® Scotch Bright Molding Adhesive and Stripe Removal Disc,
or equivalent |
| • | 3M® General purpose Adhesive cleaner 08984,
or equivalent |
Installation Procedure
- Clean the contact surface
of the fender with 3M® General Purpose Adhesive Cleaner 08984, or equivalent.
- Preheat the fender molding and the mounting surface of the fender
to 32-38°C (90-100°F).
- Peel the protective liner paper from the adhesive on the new molding.
- Position the molding.
| • | Forward of the rear edge of the fender 3 mm (0.1 in) |
| • | In line with the door molding |
- Press the molding firmly to the fender using a hand roller to
wet out the entire length of the molding.
