Important: Use hand tools to remove and install the crossmember bolt nuts.

1. Raise the vehicle and suitably support. Refer to Lifting and Jacking the Vehicle

in General Information.

2. Using hand tools remove the nut from the crossmember bolt to be replaced.
3. Lower the vehicle.
4. Open the hood.
5. Remove the battery heat shield, (if removing the right rear bolt only).



6. Drill out the crossmember bolt anti rotation device rivet.
7. Remove the bolt.

Important: Each time a crossmember bolt nut is removed it must be replaced with a new nut.

Important: Check the new bolt against the old bolt for proper length.

1. Install the crossmember bolt.
2. Install the crossmember bolt anti rotation device rivet.



3. Raise the vehicle and suitably support. Refer to Lifting and Jacking the Vehicle

in General Information.

4. Using hand tools install and tighten a NEW crossmember bolt nut.

Tighten
Tighten the crossmember nut to 110 N·m (81 lb ft).

5. Lower the vehicle.
6. Install the battery heat shield (if removed to replace the right rear crossmember bolt).