DTC B2265 -- Vertical Position Sensor -- Fault -- DCM-Right
Step
| Action
| Value(s)
| Yes
| No
|
1
| Is DTC B2263 also set?
|
|
Go to Step 2
|
Go to Step
6
|
2
|
- Disconnect the right power mirror connector C2.
- Measure the voltage between the right power mirror connector C2
terminal A to ground.
Is the voltage within the specified range?
| 4.5-5.5V
|
Go to Step 3
|
Go to Step 5
|
3
| Measure the voltage between the right power mirror connector
C2 terminal A and terminal C.
Is the voltage within specified range?
| 4.5-5.5V
|
Go to Step 4
|
Go to Step 9
|
4
| Replace the right power mirror.
Is the repair completed?
|
| Recheck the System Operation
|
|
5
|
- Check for an open or short to ground in CKT 788.
- If OK, replace the right Door Control Module (DCM).
Is the repair complete?
|
| Recheck the System Operation
|
|
6
|
- Disconnect the right power mirror connector C2.
- Measure the voltage between the right power mirror connector C2
terminal B and ground.
Is the voltage within the specified range?
| 3.5-5.5V
|
Go to Step 7
|
Go to Step 8
|
7
| Replace the right power mirror.
Is the repair complete?
|
| Recheck the System Operation
|
|
8
|
- Check for an open, a short to ground, or a short to battery in
CKT 787.
- If OK, replace the right Door Control Module (DCM).
Is the repair complete?
|
| Recheck the System Operation
|
|
9
|
- Check for an open or a short to battery in CKT 1251.
- If OK, replace the right Door Control Module (DCM).
Is the repair complete?
|
| Recheck the System Operation
|
|
