GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1998 🢒 Corvette 🢒 Steering 🢒 Steering Wheel and Column - Tilt 🢒 Tilt Spring Replacement

Removal Procedure

    Object Number: 82178 Size: SH
  1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
  2. Repeat steps 1 through 9 in the shroud removal procedure. Refer to Steering Column Trim Cover Replacement - On Vehicle .
  3. Use the tilt lever to tilt the column to the up position.

    4. Object Number: 82177 Size: SH
  4. Perform the following steps to remove the tilt spring:
    5. 4.1. Pry the spring up until a bulge occurs.
    4.2. The spring tension is mostly removed.
    4.3. Secure the spring with locking pliers.
    4.4. Continue to pry until the spring disengages from the post on the steering column support assembly and the column tilt head assembly.

    Object Number: 82182 Size: SH
  5. Remove the spring guide from the tilt spring.

Installation Procedure

    Object Number: 82182 Size: SH
  1. Install the spring guide to the tilt spring.

    2. Object Number: 82183 Size: SH
  2. Perform the following steps to install the tilt spring with the guide:
    3. 2.1. Install the spring to the post on the steering column support assembly.
    2.2. Secure the spring with locking pliers.
    2.3. With end of spring on the post; pull on the center of the spring while pushing the guide end to the post on the steering column tilt head assembly.
    2.4. With both ends installed to the post; push the spring into position.
  3. Repeat steps 1 through 11 in the shroud installation procedure. Refer to Steering Column Trim Cover Replacement - On Vehicle .
  4. Complete all service operations.
  5. Enable the SIR system. Refer to Enabling the SIR System in SIR.