DEFINITION: The wiper motor continues to run after the wiper switch is turned to the OFF position.

Were you sent here from the Wiper/Washer System Check?

--

Go to Step 2

Go to Wiper/Washer System Check

1. Turn the ignition switch to the ON position.
2. Turn the wiper switch OFF.
3. Disconnect the wiper/washer switch connector C219.

Does the wiper motor keep running?

--

Go to Step 4

Go to Step 3

Replace the wiper/washer switch.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

1. Disconnect the wiper motor connector.
2. Wiper/washer switch connector C219 still disconnected.
3. Turn the ignition switch to the ON position.
4. Connect a DMM between connector C219 terminal A and ground.
5. Measure for voltage at connector C219 terminal D.

Is the voltage within the specified values?

1 volt or more

Go to Step 5

Go to Step 6

Repair a short to battery power in CKT 95.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

1. Wiper motor connector still disconnected.
2. Wiper/washer switch connector C219 still disconnected.
3. Ignition switch still in the ON position.
4. Connect a DMM between connector C219 terminal B and ground.
5. Measure for voltage at connector C219 terminal B.

Is the voltage within the specified values?

1 volt or more

Go to Step 8

Go to Step 7

1. Wiper motor connector still disconnected.
2. Wiper/washer switch connector C219 still disconnected.
3. Ignition switch still in the ON position.
4. Connect a DMM between connector C219 terminal D and ground.
5. Measure for voltage at connector C219 terminal D.

Is the voltage within the specified values?

1 volt or more

Go to Step 9

Go to Step 10

Repair a short to battery power in CKT 91.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Repair a short to battery power in CKT 92.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Replace the wiper motor assembly.

Is the repair complete?

--

Go to Wiper/Washer System Check

--