Removal Procedure
- Preheat the emblem to between 32°-38°C (90°-100°F)
to aid in the removal of the molding.
- Peel the emblem from the fascia.
- Clean any remaining adhesive from the fascia using either a stripe
removal disc or suitable cleaner.
| • | 3M® Scotch Bright Molding Adhesive and Stripe Removal Disc,
or equivalent. |
| • | 3M® General Purpose Adhesive Cleaner 08984, or equivalent. |
Installation Procedure
- Clean the contact surface of the fascia with a suitable cleaner. Use 3M®
General Purpose Adhesive Cleaner 08984, or equivalent.
- Warm the emblem and the emblem contact area of the fascia to 32-38°C
(90-100°F).
- Remove protective liner from the adhesive on the emblem.
- Install the emblem to the locator holes in the fascia.
- Press firmly on the emblem to secure the adhesive. Use a hand
roller to wet out the entire emblem surface,
