Problem

Creak when turning the steering wheel.

Possible Cause

The steering wheel surround tabs are moving on the steering wheel hub.

Correction

1. Remove the drivers inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
2. Spread the surround tabs and remove the surround from the hub.
3. Lubricate the steering wheel hub where the tabs make contact with a petroleum free lubricant.
4. Reinstall the surround and the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.

Problem

Itch from the instrument panel cluster.

Possible Cause

The cluster bezel is rubbing against the cluster lens.

Correction

1. Road test, and apply pressure to the bezel and listen for itch to go away.
2. Remove the Cluster.
3. Remove the bezel.
4. Glue a 1 mm (3/16 in) thick washer between the bezel and the cluster at each of the upper attaching screws.
5. Install the cluster.

Problem

Rattle from the center of the instrument panel (I/P).

Possible Cause

The I/P pad attaching screws at the center defroster vent are loose.

Correction

1. Road test while applying pressure to the vent area of the I/P pad and listen for the noise to stop.
2. Remove the center defroster vent and tighten the I/P pad attachment screws.
3. Reinstall the defroster vent.

Problem

Rattle from the forward edge of the instrument panel pad.

Possible Cause

Not enough insulator foam between the instrument panel and the pad.

Correction

1. Road test and apply hand pressure to the forward edge of the instrument panel pad to find the location of the rattle.
2. Remove the Instrument panel pad.
3. Install added insulation at the point of rattle to the underside of the pad.

Problem

Buzz from the sunshade.

Possible Cause

The sunshade mirror light lens is loose.

Correction

1. Road test while applying pressure to the lens to stop the noise.
2. Remove the lens.
3. Place a small piece of foam in the lens opening.
4. Reinstall the lens.

Problem

Rattle from the sunshade in the up position.

Possible Cause

The roof latch handle is on a angle allowing contact with the sunshade.

Correction

1. Road test, reposition the sunshade and listen for the noise to stop
2. Check the latch handle and the mirror cover for signs of contact.
3. Adjust the latch handle to be parallel to the striker. Be sure to retain the same locking pressure.

Problem

Rattle from the sunshade.

Possible Cause

The sunshade rod end is vibrating in the retention clip.

Correction

1. Road test, and apply pressure to the sunshade and listen for noise to change.
2. Replace the retention clip.