- Lubricate the NEW fuel injector O-ring seals with clean engine oil.
- Install the O-ring seals onto the fuel injectors.
- Note the location of the fuel rail ground strap (1) on the intake manifold.
- Install the fuel rail, with fuel injectors, into the intake manifold.
- Apply a 5 mm (0.2 in) band of threadlock GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the threads of the fuel rail bolts.
- Install the fuel rail bolts.
Important: DO NOT use fuel injector O-ring seals again. Install NEW fuel injector O-ring seals during assembly.
The fuel rail ground strap must be installed during assembly.
Press evenly on both sides of the fuel rail until all of the injectors are seated in their bores.
Caution: The fuel rail stop bracket must be installed onto the engine assembly. The stop bracket serves as a protective shield for the fuel rail in the event of a vehicle frontal crash. If the fuel rail stop bracket is not installed and the vehicle is involved in a frontal crash, fuel could be sprayed possibly causing a fire and personal injury from burns.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fuel rail bolts to 10 N·m (89 lb in).
