Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Important: Ensure that the engine harness leads (3, 4) are positioned on the solenoid prior to the positive cable terminal being installed.
Tighten
Tighten the positive battery cable nut to 8 N·m (71 lb in).
Important: Ensure that two fingers of the heat shield bracket are on either side of the heat shield, and the shield is inserted into the notch in the insulator.
Tighten
Tighten the positive battery cable nut to 10 N·m (89 lb in).