For 1990-2009 cars only
Removal Procedure
- Open the hood.
- Drain the washer solvent from the washer solvent container.
- Disconnect the washer solvent container level sensor electrical connector.
- Remove the washer solvent container nuts.
- Remove the heater hose retention clamp from the mounting stud.
- Remove the washer solvent container from the mounting studs to gain access to the washer pump.
- Disconnect the washer pump electrical connector.
- Disconnect the washer pump hose.
- Remove the washer solvent container from the vehicle.
Installation Procedure
- Position the washer solvent container to the vehicle.
- Connect the washer pump hose.
- Connect the washer pump electrical connector.
- Install the washer solvent container onto the mounting studs.
- Install the heater hose retention clamp onto the mounting stud.
- Install the washer solvent container nuts.
- Connect the washer solvent container level sensor electrical connector.
- Fill the washer solvent container with washer solvent.
- Close the hood.
- Inspect the washer system for proper operation.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the nuts to 8 N·m (71 lb in).
